That bathroom tile once looked terrific, so newly laid contrast between tile and grout. You were so proud to show it off to all your guests.
But over time, grout becomes dull, stained and chipped. Tiles fade and look dated. When they do, it's time to refreshen or replace tile and grout.
If you love the tile, keep it. Refresh the grout to make that tile job look sparkling and new. If not, replace the flooring too. Here's how to refresh or replace tile and grout.
What you'll need
- Margin float
- Sponge
- Earplugs (if using power tools)
- Safety glasses
- Rotary tool (required for big re-grouting jobs)
- Manual grout removal tool with a carbide blade (for smaller spaces)
- Grout
If also replacing tiles, you'll need:
- Tiles (measured and cut as required)
- Chisel
- Floor scraper
- Drop sheet (for debris)
- Hammer
- Notched trowel
- Thin-set mortar
And we're ready to do this!
Cut away the grout
First, put on your safety glasses. Now use your rotary tool or grout removal tool to loosen the grout between each tile. It should chip away and pull right out.
In either case, work slowly to avoid damaging your tiles. If at any point you feel you've taken on more than you can handle, contact a professional.
Mix & apply grout
Mix your grout in a bucket. Then apply it using your margin float. Let it set for 10 minutes. Then clean the tiles with your moist sponge.
And you're done. Don't your re-grouted tiles look fantastic! It really is that simple. But what if you want to replace the tiles? You'll add some extra steps in front of mix and grout.
Remove your tiles
After removing grout as described above, use a hammer to break a tile to remove it. Be careful not to cut yourself. Now use the chisel to remove the remaining tiles. The floor scraper helps you crack and lift the adhesive underneath.
Do a dry run
Here's a pro tip! Always place your tiles out dry to make sure they fit. Then make any adjustments.
This seems like a waste of time. But unless you've tiled hundreds of bathroom floors, adjustments are almost a certainty. And once you lay mortar, you'll have a limited time to work.
Apply your mortar & place tiles
Apply a thin layer of your thin-set mortar to a small area using your trowel. Then lay each tile over it, evenly spaced. Press down gently but firmly.
After laying tiles in a small area, repeat and lay more tiles until all tiles are laid. Wait 24 hours. Then mix and apply grout as described above.
Enjoy your new floor! And follow our blog for more home maintenance and repair tips.